Xerox WORKCENTRE XE SERIES XE62 - Manual (Page 54)

45
10. Carefully remove the sheet of black
protective paper from the drum
cartridge, making sure not to leave any
torn pieces of paper in the WorkCentre.
11. Replace the toner cartridge. Hold the
handle of the toner cartridge so that the
stamped markings on top of the
cartridge are facing upward.
12. Gently insert the toner cartridge inside
the WorkCentre.
13. Push where indicated (in the illustration)
until the toner cartridge is fully inside the
WorkCentre and the handle springs
back.
14. Ensure that the WorkCentre power is on. You must hold in the button
indicated and close the door at the same time. Continue to hold the
button for 3 seconds then release the button. The 3 Copy Contrast
LEDs will flash and return to ready state. If the J2 code is still present,
repeat the process.
50% 200%
D O C U M E N T WorkCentre XE80
C