Xerox WORKCENTRE XE SERIES XE62 - Manual (Page 26)

17
Customizing Your WorkCentre
Programmable Feature Settings 0 – 7, and 14
To change the programmable features (refer to the Control Panel), find the
Program Number and the desired Option Number in the Programmable
features chart on the following pages. Follow the instructions below.
1. Select the Toner Saver in Copy Quality.
2. Press again and hold the Copy Quality button for approximately 4 to 6
seconds.
• The light next to Auto will light.
• The lights within the WorkCentre Diagram will flash.
3. From the table on the following page, select the Program Number of the
feature to be changed. Enter the selection using the 10 button.
4. Press Start.
• The current setting for that program will flash.
5. Press the 1 button until the option number you want is displayed.
6. Press Start to store the selection.
NOTE: To continue making other changes press the Clear button and
repeat steps 3 - 7. Press the Copy Quality button to return to the copy
mode.
Programmable Feature Setting 10
Use the following procedure to change the preset Reduction/Enlargement
default setting. This feature allows you to set a specific preset reduction or
enlargement between 50-200%.
1. Select the Toner Saver.
2. Press again and hold the Copy Quality button for approximately 4 to 6
seconds.
• The light next to Auto will light.
• The lights within the WorkCentre Diagram will flash.
3. Press the 10 button until the number 10 is displayed.
4. Press Start.
• The current reduction/enlargement setting will flash.
5. Press the Variable Percentage buttons until the desired percentage is
displayed.