Xerox WORKCENTRE XE SERIES XE62 - Manual (Page 53)

44
5. Place the toner cartridge on the scrap paper prepared in step 2.
The fusing unit beneath the drum cartridge becomes very hot
when the WorkCentre is in use. Be careful not to touch the fusing
unit when removing the drum cartridge.
6. Hold the tabs on the drum cartridge handle
between your thumbs and index fingers,
and gently pull the drum cartridge up and
out in a circular motion to lift it clear of the
WorkCentre.
7. Remove the new drum cartridge from the
plastic bag and set it down on a clean,
uncluttered and level surface.
The new drum cartridge is sealed with a sheet of black protective
paper to shield the drum from light. To prevent damage to the
drum surface, do not remove the protective paper until you have
inserted the cartridge into the WorkCentre.
8. Place the used cartridge into the empty bag, seal the bag.
NOTE: Help the environment by recycling your used drum cartridge. Use
the recycle sticker packed with the drum cartridge for instructions on
returning the used drum cartridge to Xerox.
9. Hold the tabs on the new drum cartridge
handle between your thumbs and index
fingers. Slide the drum cartridge along the
runners into the WorkCentre.