Yamaha 9000 Pro - Manual (Page 87)

Sampling Sampling
Reference 87
■ Pre Effect
You can set up a maximum of three DSP effects to be applied to the source sound as it
is sampled. The DSP blocks are connected in series as shown below. The following dis-
play will be shown in step #10 on page 40.
Importing Wave Files from Disk
To import previously saved waveform files via the PSR-8000 or standard WAV or AIFF
format files from disk, insert the appropriate disk into the 9000Pro floppy disk drive,
then press the [FILE IMPORT] LCD button in step #3 in "Basic Procedure" on page
86.
Clearing Wave Data
The explanations here apply to step #4 of the Basic Procedure on page 86.
Change the balance between the
direct (dry) and effect (wet) sound.
Select the desired
DSP block.
Select the desired
type of the selected
DSP block.
Select the parameter and adjust the
value of the selected parameter.
Note that the contents of the parameter
may be different depending on the
selected DSP type.
Select this to call up the
storing display.
Press this button to
switch between the cur-
rently selected wave and
the currently selected
panel voice.
Select this and press the
[NEXT] button to call up the
display that imports the
wave data sampled via the
PSR-8000.
Select this and press the
[NEXT] button to call up the
display that imports the
WAV or AIFF format file.
Select this to execute the
Clear operation.
Press this button to switch
between the currently
selected wave and the cur-
rently selected panel voice.
85