Yamaha 9000 Pro - Manual (Page 178)

MIDI Functions MIDI Functions
178 Reference
MFC10 Settings
Various functions can be assigned to an optional Yamaha MFC10 MIDI Foot Controller
connected to the 9000Pro.
Connect the MFC10 to the MIDI B terminals and set the MIDI channel for the MFC10
messages by following the on-screen instructions.
The 9000Pro provides two ways to set: Easy Setup and Full Setup.
The explanations here apply to step #5 of the Basic Procedure on page 174.
■ Easy Setup
Follow the on-screen instructions to call up the template display as shown below.
MIDI cable
MIDI OUT MIDI IN
MIDI IN MIDI OUT
MFC10
9000Pro
NEXT BACK
PAGE CONTROL
Select a template.
Press the [NEXT] button to enable
the selected Easy Setup template.
Disconnect the MIDI cable from the
MIDI OUT B terminal and connect it
to the MFC10 Foot Controller.
• When setting up the MFC10
from the 9000Pro, a MIDI cable
must be connected from the
MIDI OUT of the 9000Pro to
the MIDI IN of the MFC10.
However, you should discon-
nect this cable when using the
MFC10, since extraneous MIDI
messages may be transmitted
from the 9000Pro.
• To exit from the MFC10 play
mode, select the MIDI Tem-
plate display (page 174) and
press the [CANCEL] LCD but-
ton.
• The MFC10 play mode on/off
status is retained in Flash
ROM and is maintained even
when the power is turned off.
• When the MIDI B terminals are
connected to the MFC10, the
functions of the MIDI B port are
limited. For details, refer to the
MIDI Data Format (page 228).
176