Yamaha 9000 Pro - Manual (Page 115)

Song Creator Song Creator
Reference 115
■ Track Mixing
This function allows data from two tracks can be mixed and the results placed in a dif-
ferent track , or data to be copied from one track to another.
■ Note Shift
This allows tracks which contain data to be individually transposed up or down by a
maximum of two octaves in semitone increments.
Song Setup (Multi Track Recording)
This function lets you assign the DSP effect block (4~7) to any of the current song’s
tracks. Other parameters can be modified up as required via the MIXING CONSOLE
display (page 144).
Press this to execute the Track
Mix operation.
After execution the this button
changes to an UNDO button
which can be used to undo the
copy/mix operation if the
results are not satisfactory (the
“UNDO” button will only remain
active until the next operation is
performed).
Specify the tracks to be mixed. Select the track into which the
results will be placed.
To simply copy from the SOURCE1 track to the DESTINA-
TION track select COPY via the SOURCE2 LCD buttons.
• All data other than the mixed
note data is derived from the
SOURCE1 track.
• The Part Assign parameters of
the Plug-in Voice are not cop-
ied to the destination part even
if the Track Mix operation is
executed. Therefore, set the
Part Assign parameter (in the
System Exclusive - XG param-
eters) to the corresponding
Part number in the Event List
display (page 120) after exe-
cuting the Track Mix operation.
For details about the Part
Assign parameters, refer to the
Owner's Manual of your Plug-
in Board.
Set the desired amount of transposition for
each track (note-shift controls will only
appear for tracks which contain data).
Press this to execute the Note
Shift operation.
After execution this button
changes to an UNDO button
which can be used to undo the
Note Shift operation if the results
are not satisfactory (the “UNDO”
button will only remain active
until the next operation is per-
formed).
Adjust any track while
holding this button to
set the note shift for all
tracks simultaneously.
The TR1~8/TR9~16
LCD button can be
used to switch
between tracks 1
through 8 and tracks
9 through 16.
The tempo of the song
can be set as required via
the Data dial, and all other
available parameters can
be modified as required
via the MIXING CON-
SOLE displays.
Press this to record
the settings to the
current song.
Assign the DSP effect
block (4~7) to any of the
current song’s tracks.
• Only one of the Setup parame-
ters can be recorded to each
track, and any parameter
changes made in the middle of
the song will be cancelled.
However, in the case of Volume
and Tempo data, any Volume
and Tempo changes in the mid-
dle of the song are applied as
an offset to the initial Setup
Data setting.
113