ZyXEL Communications Prestige 642 - Manual (Page 89)

Prestige 642 ADSL Internet Access Router
6-4 IPX Configuration
6.3 IPX Ethernet Setup
From Menu 3 - Ethernet Setup, enter 3 to go to Menu 3.3 - Novell IPX Ethernet Setup as shown in the
figure below.
Figure 6-3 Menu 3.3 - Novell IPX Ethernet Setup
The following table describes the Novell IPX Ethernet Setup Menu.
Table 6-1 Novell IPX Ethernet Setup Fields
Field Description Options
Seed Router Determine if your Prestige 642 is to act as a seed
router. Yes/No
Frame Type Enable/Disable the individual frame type.
Remember to enable only the ones that are actually
used on your network. 802.2
802.3
Ethernet II
SNAP
IPX Network
# If your Prestige 642 is a seed router, enter a unique
network number for each frame type enabled.
Press [ENTER] at the message [Press ENTER to Confirm ...] to save your
configuration, or press [Esc] at any time to cancel.
Menu 3.3 - Novell IPX Ethernet Setup
Seed Router= No
Frame Type 802.2= Yes
IPX Network #= N/A
Frame Type 802.3= No
IPX Network #= N/A
Frame Type Ethernet II= No
IPX Network #= N/A
Frame Type SNAP= No
IPX Network #= N/A
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.