ZyXEL Communications Prestige 642 - Manual (Page 128)

Prestige 642 ADSL Internet Access Router
Internet Access 3-11
Table 3-4 Internet Access Setup Menu Fields
Field Description Options/E.G.
ISP’s Name Enter the name of your Internet Service Provider, e.g., myISP.
This information is for identification purposes only. e.g., MyISP
Encapsulation Press the spacebar to select the method of encapsulation
used by your ISP. PPoE(default),
PPP, RFC 1483
or ENET
ENCAP.
Multiplexing Press the [Space Bar] to select the method of multiplexing
used by your ISP - either VC-based or LLC-based. VC-based LLC-
based
Service Name
This is valid only when you have chosen PPPoE
encapsulation. If you are using PPPoE encapsulation, then
type the name of your PPPoE service here.
poellc
VPI # Enter the Virtual Path Identifier (VPI) that the telephone
company gives you. e.g., 0
VCI # Enter the Virtual Channel Identifier (VCI) that the telephone
company gives you. e.g., 35
My Login Enter the login name that your ISP gives you. If you are using
PPPoE encapsulation, then this field must be of the form
user@domain where domain identifies your ISP.
e.g., tarbuck
My Password Enter the password associated with the login name above. ***
Single User Account Press the spacebar to enable or disable SUA. Please see the
following section for a more detailed discussion on the Single
User Account feature. Yes/No
IP Address
Assignment
Press the [Space Bar] to select Static or Dynamic address
assignment. Static /
Dynamic
IP Address Enter the IP address supplied by your ISP if applicable. e.g.,
192.168.1.100
ENET ENCAP
Gateway
Enter the gateway IP address supplied by your ISP if
applicable. e.g.,
192.168.1.1
When you have completed this menu, press [Enter] at the prompt [Press ENTER to Confirm…] to save your
configuration, or press [Esc] at any time to cancel.