Wayne-Dalton TORQUEMASTER 9800 - Manual (Page 33)

33
Tools Needed:
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
OPTIONAL
INST
ALLA
TION
Side Lock
Install the side lock on the second
section of the door. secure the lock to
the section with (4) 1/4”- 20 x 11/16”
self drilling screws. square the lock
assembly with the door section and
align with the square hole in the vertical
track. The side lock should be spaced
approximately 1/8” from the section
edge.
IMPORTANT: sIDE lOCks MusT bE
REMOVED OR MaDE INOPERaTIVE IN
ThE uNlOCkED POsITION IF aN
OPERaTOR Is INsTallED ON ThE DOOR.
NOTE: after completing this step,
continue with step 10 on page 16.
�
(4) 1/4”- 20 x 11/16”
sElF DRIllING sCREWs
1/8”
Power Drill
7/16” socket
Driver
Pull Rope
Measure and mark the jamb
approximately 48” to 50” (1220 to 1270
mm) from floor on the right or left side of
door. Drill 1/8” pilot hole for No. 6 screw
eye. Tie the pull rope to the No. 6 screw
eye and to the bottom bracket as shown.
DO NOT INsTall Pull ROPEs
ON DOORs WITh ElECTRIC
OPERaTORs. ChIlDREN May
bECOME ENTaNGlED IN ThE
ROPE CausING sEVERE OR FaTal
INjuRy.
NO. 6 sCREW EyE
Pull ROPE
bOTTOM bRaCkET
Pull ROPE
wARNINg
�
Power Drill
1/8” Drill bit