Wayne-Dalton TORQUEMASTER 9800 - Manual (Page 28)

Tools Needed:
28
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
Rear Support
26
Ratchet Wrench
1/2” socket
1/2” Wrench
(2) Vice Clamps
Tape Measure
level
hammer
DOOR IN ThE
uP POsITION
VERTICal
TRaCk
VICE
ClaMPs
Raise the door until the top section
and half of the next section are in a
horizontal position. Do not raise door
any further since rear of horizontal track
is not yet supported. Do not space the
track more than 3/4” from door edge.
RaIsING DOOR FuRThER CaN
REsulT IN DOOR FallING aND
CausE sEVERE OR FaTal INjuRy.
kEEP hORIzONTal TRaCk
PaRallEl aND WIThIN 3/4”
MaxIMuM OF DOOR EDGE,
OThERWIsE DOOR COulD Fall,
REsulTING IN sEVERE OR FaTal
INjuRy.
Clamp a pair of vice clamps on the
vertical tracks just above the second
roller on one side, just below the
second roller on the other side. This
will prevent the door from raising
or lowering while installing the rear
support. Fabricate rear support for
horizontal tracks, using perforated
angle, 5/16” x 1-5/8” hex head lag
screws and 5/16” bolts with nuts (may
not be supplied). attach horizontal
tracks to the rear supports with 5/16”-
18 x 1-1/4” hex bolts and nuts (may not
be supplied). horizontal tracks must be
level and parallel with door.
IMPORTANT: IT Is NOT RECOMMENDED
ThaT aNy PaRT OF ThE hORIzONTal
TRaCk haNGER ThaT CaNTIlEVERs 4”
bEyOND a sOuND FRaMING MEMbERs
bE usED TO suPPORT ThE WEIGhT OF
ThE DOOR.
NOTE: If perforated angle is installed
over drywall, use 5/16” x 2” hex head
lag screws.
adjust weather seal or door stop (if
necessary) and now permanently attach
the weather seal or door stop to both
door jambs and header. (They were
temporarily attached to the jambs in
PREPaRING ThE OPENING on page 10.)
avoid pushing weather seal or door stop
too tightly against face of door.
wARNINg
wARNINg
DOOR EDGE hORIzONTal
TRaCk
3/4”
PERFORaTED
aNGlE
(3) 5/16”
NuTs
(3) 5/16”
bOlTs
wEAThER SEAL
quICk INsTall TRaCk Fully aDjusTablE TRaCk
jaMb
WEaThER
sEal
1/8” TO 1/4”
WEaThER
sEal
jaMb
DOOR
sTOP
DOOR
sTOP
DOOR
sECTION
DOOR
sECTION
jaMb jaMb 1/8” TO 1/4”