Trimble Outdoors 5700 - Manual (Page 38)

2 Setting up the Receiver
2 2 5700 GPS Receiver User Guide
Op
eration
Mounting the TSC1 data collector
To mount the TSC1 data collector on the pole:
1. Mount the handheld bracket on the pole:
a. Place the bracket against the pole at a comfortable height.
b. Close the gates of the bracket around the pole.
c. Seat the base of the clip lock in the opposite gate.
d. Lock the clip lock down.
If the clip lock is too tight to be locked, turn it one or two
turns counterclockwise and try again. If it is too loose, turn
it one or two turns clockwise and try to lock it again.
The cables running down the pole should fit into the
groove so that the bracket clamps them in.
Note – If you are using a 1" diameter pole, flip the black
insert around inside the bracket, as shown in Figure 2.8,
before securing.
Figure 2.10 Handheld bracket