Tripp Lite B020-016-17 - Manual (Page 2)

1. Features 3
2. System Requirements 4
2.1 Computer 4
2.2 Console 4
2.3 Cables 4
3. Introduction 5
3.1 Front View of Console KVM Switch 5
3.2 Front View of B022-016 6
3.3 Rear View of Console KVM Switch 7
3.4 Rear View for B022-016 7
4. Installation 8
4.1 Rackmounting guidelines 8
4.2 Rackmounting Instructions for Console KVMs 8
4.3 Rackmounting for B022-016 9
4.4 Single-Station Installation 9
4.5 Multiple Station (Daisy-Chained) Installation 9
4.6 Hot Plugging 10
5. Basic operation 10
5.1 opening the NetDirector Console KVM 10
5.2 Closing the NetDirector Console KVM 11
5.3 LCD oSD (on-Screen Display) Configuration 11
6. Hotkeys 12
6.1 Port Selection 12
6.2 Port Control Using Hotkeys 12
6.3 Invoking the Hotkey Mode 12
6.4 Port ID Numbering 13
6.5 Selecting the Active Port 13
6.6 Auto Scanning 13
6.7 Setting the Scan Interval 13
6.8 Starting Auto Scan 14
6.9 Pausing in Auto Scan 14
6.10 Skip Mode 14
6.11 Hotkey Beeper Control 15
6.12 Hotkey Summary Table 15
7. oSD (on-Screen Display) operation 16
7.1 oSD overview 16
7.2 oSD Navigation 16
7.3 oSD Main Screen Headings 17
7.4 oSD Functions 17
8. Firmware Upgrade Utility 22
8.1 Before you Begin 22
8.2 Starting the Upgrade 23
8.3 Upgrade Succeeded 24
8.4 Upgrade Failed 24
8.5 Firmware Upgrade Recovery 25
9. Appendix A 26
9.1 Troubleshooting 26
9.2 Specifications 26
9.3 oSD Factory Default Settings 27
10. Appendix B 27
10.1 FCC Radio/TV Interference Notice 27
11. Warranty 28
12. Warranty Registration 28
2
Table of Contents