Tektronix Phasershare Printer - Manual (Page 74)

8
Setting the Printer’s IP Addressing Parameters
68 PhaserShare Networking
To set up the printer for DNS, supply an IP domain name and up to two DNS
name server IP addresses. There are three ways to set up the printer:
■ BOOTP (UNIX). See “Setting IP parameters: RARP or BOOTP” on
page 61.
■ DHCP (Windows). See “Setting IP parameters: DHCP” on page 62.
■ With TCP/IP, you can use PhaserLink. See the next topic, “Setting up
the printer for DNS using PhaserLink software”.
Setting up the printer for DNS using PhaserLink software
After setting the printer’s IP address by one of the methods described
previously in this chapter, you can set up the printer for DNS using PhaserLink
software, if you have a World Wide Web browser. For more information on
PhaserLink software, see Chapter 9, “PhaserLink Software: the Printer’s
Information Link”.
1. From the printer’s home page, click Configuration; this displays the
View and Configure Settings
page.
2. From the View and Configure Settings page, click View and
Configure Interface Settings
; this displays the View and Configure
Interface Settings page.
3. From the View and Configure Interface Settings page, click View and
Configure TCP/IP Settings
; this displays the View and Configure
TCP/IP Settings page.
4. Set the Domain Name Service Resolver Enabled field to Yes.
5. Enter the following information:
■ Primary Name Server IP Address (required)
■ Second Name Server IP Address (optional)
■ IP Domain Name (required)
■ Additional Search Domain Name(s) (optional)
6. When you are finished entering the settings, enter the Validation
Password
and click Do/Apply.
7. The printer displays a dialog box that allows you to reset the printer.
New parameters will not take effect until the printer is reset.