Tektronix Phasershare Printer User Manual
Page 62
8
Setting the Printer’s IP Addressing Parameters
56
PhaserShare Networking
c.
Press
Menu
to display the IP address. For example:
IP Address
192.2.194.101 Select
d.
Press
to set the left-most digit of the address.
e.
Press
to advance to the next digit. Press
to set this digit.
f.
Use
and
as described in Step e to set the remaining digits.
g.
When the address is correctly set, press
Select
; the front panel
displays the IP Address with a
Confirm
button.
h.
Press
Confirm
; the front panel briefly displays
Selected
, then
displays the IP address again. The IP address is now set in the
printer.
i.
Press
;
the front panel displays:
TCP/IP
IP Address Menu
6.
To set the network mask:
a.
Press
until
Network Mask
is displayed.
b.
Press
Menu
; the front panel displays the network mask.
c.
Use
and
as described in Steps 4d through 4f to set the
network mask.
d.
When the network mask is set, use
Select
and
Confirm
as
described in Steps 4g and 4h to enter the network mask into the
printer.
e.
Press
;
the front panel displays:
TCP/IP
Network Mask Menu
N
O
T
E
Setting the IP address to 000.000.000.000 causes the printer to use Dynamic
Address Resolution to set its IP address (see “Setting IP parameters: RARP or
BOOTP” on page 61).