Tektronix Phasershare Printer User Manual
Page 59
Setting the Printer’s IP Addressing Parameters
8
Setup Guide
53
Setting IP parameters: Phaser 740 printer front panel
N
O
T
E
When you set the IP addressing parameters from the front panel, the selections
for DHCP/BOOTP and RARP are automatically set to
Disabled
.
1.
Press
Menu
; the front panel displays
Help Pages
.
2.
Press
---->
or
<----
until the front panel displays
Network
Settings
.
3.
Press
Menu
until the front panel displays
TCP/IP
.
4.
To set the IP address:
a.
Press
Menu
again; the front panel displays
Interface
.
b.
Press
---->
to display
TCP/IP Address
.
c.
Press
Select
to display the IP address. For example:
192.2.194.101
+ ----> Set
d.
Press
+
to set the left-most digit of the address.
e.
Press
---->
to advance to the next digit. Press
+
to set this digit.
f.
Use
---->
and
+
as described in Step e to set the remaining digits.
g.
When the address is correctly set, press
Set
to enter your settings
into the printer; the front panel displays:
Confirm Selection
Confirm
h.
Press
Confirm
; the front panel briefly displays
Selected
, then
returns to
TCP/IP Address
. The IP address is now set in the
printer.
N
O
T
E
Setting the IP address to 000.000.000.000 causes the printer to use Dynamic
Address Resolution to set its IP address (see “Setting IP parameters: RARP or
BOOTP” on page 61).