Tektronix Phasershare Printer - Manual (Page 23)

Connecting Your Printer to a Network 2
Setup Guide 17
3. Run the script config-TokenRing:
a. In the directory where you placed your printer’s network utilities,
change (cd) to the bin subdirectory.
b. Type the name of the script, redirecting the output to a file. Type:
config-TokenRing > filename
4. When prompted by the script, enter the Token Ring parameters.
5. When the script is finished, log in as root.
6. Make an entry into the host’s ARP (Address Resolution Protocol) table
defining the printer’s Printer Name/Token Ring address pair. In
general, this requires a command corresponding to one of the
following syntax examples:
arp -s printer-name Token-Ring-address (for BSD systems)
or
arp -s ether printer-name Token-Ring-address (for System V)
See the documentation for your host system for specifics of this
command.
7. Turn on the printer.
8. Use the host spooling system (for example, lpr or lp) to send to the
printer the file you created in Step 3b; this stores the Token Ring
information in the printer’s memory, where it is retained over a reset or
power cycle.
9. Reset the printer to make the changes take effect.