Tektronix Phasershare Printer User Manual
Page 66
8
Setting the Printer’s IP Addressing Parameters
60
PhaserShare Networking
7.
The printer calculates the broadcast address based on the IP address
and the network mask. In most cases, this calculated value is correct
and there is no need to set the broadcast address. However, the
broadcast address can be viewed and set using the following
procedure:
a.
Press
---->
until
Broadcast Address
is displayed.
b.
Press
Menu
; the front panel displays the broadcast address.
c.
Use
Increment
and
Shift
as described in 4d through 4f to set
the broadcast address.
d.
When the broadcast address is set, use
Select
and
Confirm
as
described in Steps 4g and 4h to enter the broadcast address into the
printer.
8.
Return the printer to normal operation.
a.
Press
Exit
until the front panel displays
Network Settings
.
b.
Press
Exit
again.
■
If you have changed any parameters that require a printer reset
to take effect, you will be prompted to reset the printer. If you
press
Reset
, the printer resets. If you press
Resume
, the front
panel displays
Network Settings
. Press
Exit
; the printer
returns to normal operation, but the changes you have made
will not take effect until the next time the printer is reset.
■
If you have not changed any parameters that require a printer
reset to take effect, the front panel displays
Ready
.