Renesas Emulator Debugger M16C PC4701 - Manual (Page 276)

11. Display the Cause of the Program Stoppage
If the program is stoped by the debug function, the cause of the stoppage is displayed in the Output
window or Status window ([Platform] sheet).
The contents of a display and the meaning of "the cause of the stoppage" are as follows.
Disp y The cause of the stoppage la
Halt The stop by the [Halt Program] button/menu
S/W break Software break
Address match interrupt break Address interrupt break
H/W event, Combination Hardware break, logical combination AND or AND(same
time)condition was met
H/W event, Combination, Ax Hardware break, logical combination OR condition was
met
(Ax: The event number of which condition was met.)
H/W event, State transition, from xx Hardware break, State Transition condition was met
(from xx: previous state (start, state1, state2))
H/W event, State transition, Timeout Hardware break, State Transition, Time Out condition was
met
H/W event, Access protect error Protect break
Note
To be able to show the cause of break or not depends on the connected target. Some targets may
always show "Halt" or show "---".
262