5 clock tab, 1 specify the target clock, 2 attempt to access memory during wait/stop mode – Renesas Emulator Debugger M16C PC4701 User Manual

Page 57

5 Setup the Debugger

5.1.5 Clock Tab

The specified content becomes effective when the next being start.

5.1.5.1 Specify the Target Clock

Change the setting by synchronizing with the clock used by the target microcomputer. (Internal is set
by default.)
(The debugger for 740 does not have designation of Sub clock.)

Select Internal to set the internal clock, and External to set the external clock.

5.1.5.2 Attempt to access memory during WAIT/STOP mode

The debugger for 740 does not have this setting.
Set this check on, when the mcu needs to access memory during WAIT/STOP mode.

When this check is ON, debugger will attempt to access memory by waiting for about 5 seconds until
the mcu returns from WAIT/STOP mode. If the mcu remains WAIT/STOP mode during this period,
the operation will receive an error. When this check is OFF, debugger will receive an error without
accessing to real memory.