Radio Shack 43-3570 - Manual (Page 11)

Installation
11
C
ONNECTING
/C
HARGING THE
B ATTERY P ACK
The phone comes with a rechargeable
nickel-metal hydride (Ni-MH) battery pack in
the handset, but not connected. Before
using your phone, you must connect the
battery pack, then charge it for about 15–20
hours.
1. Press down and slide off the battery
compartment cover.
2. Lift the battery pack out of the
compartment.
3. Plug the battery pack’s connector into
the socket in the compartment (the
connector fits only one way), then place
the battery pack in the compartment.
4. Replace the cover.
To charge the battery pack, place the
handset on the base. The
CHARGE indicator
on the base lights.
Recharge the battery pack when
Low Battery flashes on the display.
If you have trouble replacing the battery
pack, take the phone to your local
RadioShack for assistance.
Recharging the Battery Pack
• If the battery pack becomes weak
during a call, Low Battery flashes.
When this happens, you cannot make a
call until you recharge the battery
pack.
!
• If the display is blank and the phone
does not work, recharge the battery
pack. (The battery power might be too
low to light the display.)
! IMPORTANT !
Be sure the battery pack is
properly connected before
you try to charge it. The
CHARGE indicator lights
when the handset is on the
base, even if the battery
pack is not connected.