Roland AT20s - Manual (Page 67)

67
Record and Playback Your Performance
Formatting Disks
Before any floppy disk (new or used) can be used with the AT-20S, it must first be for-
matted (prepared).
Floppy disks must first be “formatted” (initialized) before they can be used by the AT-
20S to store data. “Formatting” is the process of erasing any data which may have been
on the disk and making the format of the floppy disk match the format of the device. The
AT-20S cannot use a floppy disk that has a format differing from its own format.
Formatting a disk will erase any data that may have been stored on it. Carefully check any
previously used disk to be sure it doesn’t contain any valuable data.
fig.08-11
1.
Make sure that the write protect tab of the floppy disk is in the
“Write” (permit) position.
fig.08-12
2.
With the label of the floppy disk facing upward, insert it into the disk
drive until it clicks into position.
The disk drive is located to the upper right of the AT-20S’s keyboard.
Please DO NOT insert the floppy disk into the gap between the cabinet the lid.
3.
Press the [Function] button.
NOTE
4, 6
5, 7, 8
Composer
Demo Load Save Function Registration
Stop Reset Play Rec Fwd Bwd
Select
Clear Rename
Lower Upper Solo Control Accomp Bass Rhythm
Track
3
Protect
(prevents writing to disk)
Write
(can write new data onto disk)
Write Protect Tab
NOTE
AT-20S.e.book 67 ページ ２００３年１１月１０日 月曜日 午後２時３７分