Roland AT20s - Manual (Page 51)

51
Using the Registration Buttons
Automatically Registering When You Switch
Panel Settings
When the [Manual] button is ON (lit), all panel settings you make will be stored auto-
matically in the [Manual] button as they are made, thus updating the Registration that
had been previously saved. If you change to a preset Registration [1]– [4], it is possible
to return to the previous panel settings by pressing the [Manual] button.
fig.07-03
The settings stored in the [Manual] button returns to the default settings while the power is
turned off.
Assigning a Name to a Registration Set
When saving Registration sets, names like “REGIST-01 – 99” will be assigned by default,
but you can assign a name that will help you later to identify the contents of the Regis-
tration set.
fig.07-03
1.
Make sure that the disk drive contains a disk that was formatted (p.
67) by the AT-20S.
2.
Press the [Registration] button (indicator lights).
3.
Press the [Load] button and the [Function] button simultaneously.
Write Manual 1 3 4 2
Registration
NOTE
Composer
Demo Load Save Function Registration
Stop Reset Play Rec Fwd Bwd
Select
Clear Rename
Lower Upper Solo Control Accomp Bass Rhythm
Track
2 3, 5
4
AT-20S.e.book 51 ページ ２００３年１１月１０日 月曜日 午後２時３７分