Problems with playback functions, Other problems, 270 troubleshooting – Roland AT800 User Manual
Page 270
270
Troubleshooting
-
Problems with Playback Functions
Problem
Check
Solution
Page
Moving your hand over the D
Beam controller does not produce
a sound
If a D Beam button is lit in red, moving
your hand above the D Beam controller
will apply an effect to the sound you
play from the Upper keyboard.
Press the D Beam button once again so
the button is lit in green.
Can’t use the function assigned to
the foot switch
If “Registration Shift” (change
Registrations) is “RIGHT,” “LEFT,” or
“RIGHT + Load Next,” the foot switch
will be dedicated to switching the
Registration.
Turn “Registration Shift” off.
Damper Pedal does not operate
The damper pedal affects only the
Lower keyboard and Upper keyboard.
The damper pedal does not affect the
Bass pedalboard.
You can change the settings so that the
damper pedal affects the Upper
keyboard.
The damper pedal does not affect the
Solo voice.
This is not a malfunction.
- - -
Expression Pedal does not
operate
The function of the Expression Pedal
during recording or the function during
playback has been set to
“COMPOSER.”
Set the expression pedal function during
recording to “PEDAL,” and during
playback to “PEDAL” or
“PEDAL+COMPOSER.”
Other Problems
Problem
Check
Solution
Page
Can’t read/write USB memory
Could you be using USB memory not
made by Roland?
We cannot guarantee operation if you’re
using USB memory not made by Roland.
- - -
The external memory setting is
incorrect.
Change the external memory setting.
Remote control does not work
Could the Remote function be turned
off?
If the Remote function is turned off,
data from the remote control will not be
received.
Refer to “Turning the Remote function on/
off.”
The Touch Screen doesn’t respond
correctly
The positioning of the Touch Screen
may become displaced if some time
has passed since it was last used.
Reposition the Touch screen.
Unable to save created Rhythm to
the User Memory
“Memory Full” appears in the display.
The available memory remaining in the
ATELIER is not sufficient.
First delete some other Rhythm saved to
the user memory, then save the Rhythm
you have created to the user memory
once again.
AT-800_e.book 270 ページ ２００８年１０月１５日 水曜日 午前９時３７分