Roland AT800 - Manual (Page 245)

245
Connecting with External Device
Connecting with External Device
If connection to your computer is
unsuccessful...
Normally, you don’t need to install a driver in order to connect
the ATELIER to your computer. However, if some problem
occurs, or if the performance is poor, using the Roland
original driver may solve the problem.
Specify the USB driver you want to use, and then install the
driver.For details on downloading and installing the Roland
original driver, refer to the Roland website.
Roland website: http://www.roland.com/
Specify the USB driver you want to use for the ATELIER, and
then install the driver.
1. Touch on the Main screen.
The System screen appears.
2. Touch < > < > to display the USB Driver.
fig.10-12.eps
3. Touch the USB Driver setting to switch between
“GENERIC” and “ORIGINAL.”
Each time you touch the USB Driver setting, it will
alternate between “GENERIC” and “ORIGINAL.”
4. Turn the ATELIER’s volume to the minimum
level, switch off the power, then turn it back on
again.
This setting remains stored in memory even while power is
turned off.
Caution
• To prevent malfunction and/or damage to speakers
or other devices, always turn down the volume, and
turn off the power on all devices before making any
connections.
• Only MIDI data can be transmitted using USB.
• USB cables are not included. Consult your Roland
dealer if you need to purchase.
• Turn on the power to the ATELIER before starting up
MIDI applications on the computer. Do not turn the
ATELIER on or off while any MIDI application is
running.
Making the Settings for the USB Driver
Setting Description
GENERIC
Choose this if you want to use the
standard USB driver that was
included with your computer.
Normally, you should use this
mode.
ORIGINAL
Choose this if you want to use a
USB driver downloaded from the
Roland website.
AT-800_e.book 245 ページ ２００８年１０月１５日 水曜日 午前９時３７分