Roland KR107 - Manual (Page 17)

17
Before You
Start Playing
Before You Start Playing
Connect the Pedal Cable
Insert the pedal cable into the Pedal connector on the
rear panel of the KR107.
fig.00-01
Connect the Speaker Cable
As shown in the diagram, connect the speaker cable
leading from the speaker box of the stand to the speaker
connector located on the rear bottom panel of the KR107.
Push the speaker cable in until it clicks into position.
NOTE
Do not place containers holding liquids (such as flower vases),
insecticide, perfume, alcohol, or similar substances on top of this
piano.
The speakers of this piano are mounted beneath the upper surface,
and face upwards. Malfunctions or accidents may occur if liquids
contact any part of the speakers.
Connect the Power Cord
Insert the included power cord into the AC inlet on the
bottom panel of the KR107, and then plug it into an
electrical outlet.
NOTE
Be sure to use the supplied power cord.
fig.00-02
Setting Up the Music Rest
1. Grasping the music rest with both hands, lift it toward
you until its in the upright position.
2. Use the support on the back of the music rest to keep
the stand in place.
The angle of the music rest can be set to any of three
positions.
fig.mu_stand
■ Folding Down the Music Rest
1.
Raise the support located on the back of the music rest,
then gently fold down the music rest.
■ Using the Music Holders
You can use the holders to hold pages in place.
When not using the holders, leave them folded down.
fig.mu_stand4
KR107 Rear
Speaker cable
Speaker connector
Clip portion
Speakers
1
2
KR107_e.book 17 ページ ２００５年８月３日 水曜日 午前９時３６分