Roland KR107 - Manual (Page 120)

120
Chapter 7 Creating and Editing Songs
Chapter 7
❍ Recording a Passage Specified by Markers
1.
Before you start re-recording, place markers A and B to
define the passage.
Following the procedures described in “Setting Markers
for Repeated Practice (Marker)” (p. 85), use Markers A
and B to specify the passage.
2. In the Rec Mode screen (p. 117), select
Out>.
fig.d-rec-punch.eps_50
This changes the recording mode to “Punch-In
Recording.”
Press the [Exit] button to return to the Menu screen.
3. Begin recording.
Begin recording using the procedures described in
“Recording While Selecting the Track Buttons (Redoing
Recordings)” (p. 96) or “Multitrack Recording with 16
Parts (16-Track Sequencer)” (p. 114).
Up until the specified passage, the previously recorded
performance plays back.
When you reach the specified passage, sounds are erased
as recording starts; begin playing now.
When you reach the end of the specified passage,
recording stops, and the KR returns to playback of the
previously recorded performance.
4.
When you press the [ (Play/Stop)] button, the
song stops.
❍ Starting Recording from the Measure
Specified by Buttons and Pedals
If using the Performance Pads or pedals, you must first
change the function of the pedals and Pads. Follow the
procedures in “Assigning Functions to Pedals and
Performance Pads (Pedal Setting/User Functions)” (p. 144),
and assign to the buttons or pedal.
1. In the Rec Mode screen (p. 117), select
In/Out>.
This changes the recording mode to “Punch-In
Recording.”
Press the [Exit] button to return to the Menu screen.
2.
Begin recording.
Begin recording using the procedures described in
“Recording While Selecting the Track Buttons (Redoing
Recordings)” (p. 96) or “Multitrack Recording with 16
Parts (16-Track Sequencer)” (p. 114).
The previously recorded performance will be played
back.
Press the pedal to which Punch In/Out is assigned (p.
144), a performance pad, or the [ (Rec)] button to
begin recording, then start your performance.
Recording stops when you press the pedal, the
Performance Pad, or the [ (Rec)] button again, and
the previously recorded performance is played back.
3. When you press the [ (Play/Stop)] button, the
performance stops.
* When you’re finished with Punch-In Recording, return to the
ordinary Replace Recording mode. Take a look at “Changing
the Recording Method” (p. 117).
KR107_e.book 120 ページ ２００５年８月３日 水曜日 午前９時３６分