You can select the frame type for netware, Auto select, Ethernet ll – Ricoh BY1000 User Manual
Page 65: Ethernet 802.2, Ethernet 802.3, Ethernet snap default: auto select, You can select the active protocol, Tcp/ip, Netware, Smb default: all active
65
Making Printer Settings
Gateway Address
You can specify the gateway address.
When DHCP is set to on, the gateway address cannot be changed. To change it, set DHCP to off.
Contact your network administrator for information about the network configuration.
Default: 0.0.0.0
Frame Type (NW)
You can select the frame type for NetWare.
z
Auto Select
z
Ethernet ll
z
Ethernet 802.2
z
Ethernet 802.3
z
Ethernet SNAP
Default: Auto Select
Active Protocol
You can select the active protocol.
z
TCP/IP
z
NetWare
z
SMB
Default: All Active
Ethernet Speed
You can select the network speed to operate the printer.
z
Auto Select
z
10Mbps Half D.
z
10Mbps Full D.
z
100Mbps Half D.
z
100Mbps Full D.
Default: Auto Select
USB Setting
You can specify the settings related to communication when the computer and printer are connected via
USB. Usually, you do not need to change these settings.
USB Speed
z
Full Speed
z
Auto
Default: Auto
Port
z
On
z
Off
Default: Off
z
To use NetBEUI, enable [SMB].