Procedure 30 – Nortel Networks NN43001-318 User Manual

Page 92

Testing ISDN BRI functions

This feature gives the calling and the called parties the option of displaying
the calling line identification as follows:

•

The called party ISDN BRI terminal must have the calling line
presentation (CLIP) parameter value set to

YES

to accept the calling line

identification and show it on its display.

•

If there is an option on the ISDN BRI terminal that enables the calling
party to allow or restrict the presentation of the calling line ID on a per
call basis, select the option to allow presentation. This option on the
terminal overrides the PRES parameter values entered in the TSP
data block when configuring the TSP. This depends on the telephone
configuration default. See "TSP configuration procedures" in ISDN
Basic Rate Interface Feature Fundamentals (NN43001-580).

Procedure 30

Perform a Calling Line Identification Presentation test

Step

Action

Configure both the calling and the called party ISDN BRI terminal
DN with CLIP =

YES

and PRES =

YES

Place a call from one terminal to the other and observe the display
on the called party ISDN BRI terminal. The Calling Line Identification
should be displayed during ringing and for the duration of the call.

Release the call at the called or calling party terminal.

Set PRES =

in the TSP data block for the calling party ISDN BRI

terminal. If the calling party ISDN BRI terminal has an option on the
set to allow or restrict the presentation of the calling party number,
select the option to allow presentation and place a call to another
ISDN BRI terminal.

Observe the called party ISDN BRI terminal display. You should
see the number being displayed.

Release the call connection.

—End—

ISDN BRI Conference (National ISDN-1 and ETSI)

ISDN BRI Conference allows an ISDN BRI terminal user to bridge multiple
parties into a conversation. The user can:

•

invoke Conference on a call

•

add a new party to an existing call

Nortel Communication Server 1000

ISDN Basic Rate Interface Installation and Commissioning

NN43001-318

01.02

Standard

Release 5.0

20 June 2007