Nortel Networks NN43001-318 - Manual (Page 15)

15
Installing ISDN BRI hardware
Contents
This section contains information on the following topics:
"Installing ISDN BRI hardware for line applications" (page 15)
"Installing ISDN BRI hardware for trunk applications" (page 38)
"Selecting the card slots" (page 39)
"Removing the module cover for card installation" (page 39)
"Installing the MISP" (page 39)
"Installing the clock reference on the SILC" (page 39)
"Installing the SILC and the UILC" (page 42)
"Connecting the system to the Main Distribution Frame (MDF)" (page 42)
"Cross-connecting the Main Distribution Frame (MDF)" (page 42)
"Card location forms" (page 44)
Installing ISDN BRI hardware for line applications
The following lists the procedures for installing ISDN BRI hardware for line
applications. The system must already be installed and operating according
to the instructions in Communication Server 1000M and Meridian 1 Large
System Installation and Commissioning (NN43021-310) before performing
these procedures.
For a successful installation, perform these procedures in the order listed
below:
Step Action
1 Select the card slots where the ISDN BRI cards will be located.
2 Remove the module cover for card installation.
3 Install the Multi-Purpose ISDN Signaling Processors (MISPs).
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2003-2007, Nortel Networks
.