Nortel Networks 8005DC - Manual (Page 31)

8608SXE module 31
8608SXE module LEDs
Type Label Color/State Meaning
Green/Blinking The port is transmitting data.
Amber/Steady A fault condition exists on the line or on
the attached remote device.
TX
Off The port did not detect a fault condition.
Green/Steady The port has established a link and is
enabled.
Green/Blinking The port is receiving data.
Amber/Steady The port has either no optical signal or
no link synchronization.
Port
RX
Off The port has signal but no link.
Green/Steady The module has completed its power-on
self-test and software initialization and
is operating normally.
Amber/Steady The module failed its power-on self-test.
Module Online
Off The switch power is off. If the switch
power is on, the module is going
through its power-on self-test and
software initialization. A module in this
state is not yet functional.
The 8608SXE module supports up to 32 000 table entries in its forwarding
engine. For information about table entry characteristics, see Network
Design Guidelines (313197-E).
The Metro Ethernet Routing Switch 8600 system has three hardware
operating modes:
• Default mode (32 000 table entries) supports up to 32 000 hardware
records. This mode supports all modules.
• M mode (128 000 table entries) supports up to 128 000 hardware
records. This mode supports M modules only.
• R mode supports up to:
— 256 000 IP routes
— 64 000 MAC entries
— 32 000 ARP entries
This mode supports R modules only.
The 8608SXE module does not support R or M mode.
Nortel Metro Ethernet Routing Switch 8600
Installation — Modules
NN46220-306 02.02 Standard
4.2 7 July 2008
Copyright © 2005-2007, Nortel Networks
.