Connecting the server – Nortel Networks NN44200-300 User Manual
Page 51
Connecting the server to the Nortel server subnet (optional)
51
Connecting the server to the Nortel server subnet (optional)
Introduction
This section provides instructions to connect the server to the Nortel server
subnet.
Note: The Nortel server subnet is optional. However, a Nortel server
subnet is required to support desktop and Web messaging users.
ATTENTION
To comply with EMC radiation requirements, a Class A hub must be located 10 m
(33 ft.) away from the 1002rp server. Shielded Ethernet cables must be used.
Media Access Control address
The MAC address is a unique number assigned to network cards and
controllers. The procedure below asks you to record the CLAN MAC
address. The MAC address is recorded on a label affixed to the back of
the chassis.
To connect the server to the Nortel server subnet
Step
Action
1
See the diagram on page
"Rear panel connectors" (page 47)
to
locate the CLAN network card.
2
Locate the MAC address label on the back of the chassis that
identifies the CLAN controller MAC address.
3
Record the MAC address on the Configuration Wizard worksheet
that is provided in the Installation and Configuration Task List
(NN44200-306).
You need the MAC address to identify the CLAN when running the
Configuration Wizard to configure the CallPilot server.
Note: When connecting the optional Nortel server subnet, do
not power up unless your antivirus programs and Nortel security
updates are installed first.
4
Connect an RJ-45 network cable from the CLAN hub or switch to
the CLAN connector.
—End—
What is next?
Continue with
"Installing the Nortel software feature dongle" (page 52)
Nortel CallPilot
1002rp Server Hardware Installation
NN44200-300
01.01
Standard
5.0
23 February 2007
Copyright © 2007, Nortel Networks
Nortel Networks Confidential
.