beautypg.com

Installing the second, Introduction, Ac versus dc systems – Nortel Networks NN44200-300 User Manual

Page 34: About the power supply module

background image

34

Chapter 4 Power supply installation

Installing the second power supply module (AC or DC)

Introduction

One power supply module is shipped installed. The second power supply
module must be installed on-site.

AC versus DC systems

The power supply modules are similar in appearance for both AC and DC
1002rp servers. The procedures in this section apply to both AC and DC
1002rp servers.

About the power supply module

After the server is powered up (later in this guide), the power supply module
LED indicates its status.

A green LED on the power supply module indicates that the module is
working properly. If the LED is unlit or red, the module is failing or has failed.
A problem with the power supply module is also indicated if an alarm sounds
or the power supply LED on the front of the server turns red.

The diagram below shows the location of the power supply modules in a
server that has two power supply modules installed:

Nortel CallPilot

1002rp Server Hardware Installation

NN44200-300

01.01

Standard

5.0

23 February 2007

Copyright © 2007, Nortel Networks

Nortel Networks Confidential

.