Nortel Networks NN44200-300 User Manual
Page 48
48
Chapter 5 Installing the server and connecting the peripheral devices
2
Plug the keyboard/mouse dual cable into the PS/2 connector on the
SBC card faceplate (see
"Rear panel connectors" (page 47)
).
3
Plug the keyboard and mouse into the appropriate connectors on
the keyboard/mouse dual cable.
4
Plug the monitor into the monitor connector on the SBC card.
Tighten the screws on the connector.
5
Ensure that a single-point ground reference is available for all
the power outlets serving the CallPilot server and its peripherals.
Before the CallPilot server installation, a qualified electrician must
implement the single-point ground reference requirement between
the power outlets of the CallPilot server and the power outlets of
the switch.
6
Connect the power cord to the monitor and plug the other end into
a wall receptacle or power bar.
Note: Ensure that the power source is consistent with the SBC
for all ancillary equipment.
7
Turn on the monitor.
—End—
To connect the modem to the server
Step
Action
1
Ensure that the modem AC power cord is not plugged in.
2
Connect the large 25-pin male connector to the back of the modem.
Tighten the connector screws.
3
Connect the 9-pin female connector to COM1 at the rear of the
server. Tighten the connector screws.
4
Connect one end of the telephone cable to the modem RJ-11 jack
labeled LINE.
5
Connect the other end of the telephone cable to the RJ-11 jack in
the wall.
6
Ensure that a single-point ground reference is available for all
the power outlets serving the CallPilot server and its peripherals.
Before the CallPilot server installation, a qualified electrician must
implement the single-point ground reference requirement between
Nortel CallPilot
1002rp Server Hardware Installation
NN44200-300
01.01
Standard
5.0
23 February 2007
Copyright © 2007, Nortel Networks
Nortel Networks Confidential
.