Preparing the modem – Nortel Networks NN44200-300 User Manual
Page 44
44
Chapter 5 Installing the server and connecting the peripheral devices
WARNING
Do not connect the server to the power yet.
Preparing the modem
Introduction
You require a modem to support remote dial-up access to the CallPilot
server. The modem also enables Nortel technical support to connect to
your CallPilot server for troubleshooting purposes. Nortel connects to your
server only when you request technical assistance.
Required equipment
To install the modem, you need the following equipment:
•
an RJ-11 analog phone cord
•
a power adapter cord
•
an analog line jack
•
tweezers, or a screwdriver small enough to use to adjust DIP switches
The following modem is provided with your server:
•
an analog external U.S. Robotics 56-Kbit/s modem (NTRH9078) that
includes a 25-pin male to 9-pin female shielded serial cable for your
modem
Note: Ensure that you have the correct cable for your modem, as
follows:
— 56-Kbit/s modem: A0841984
Modem DIP switches
Set the modem DIP switches before you connect the modem to the CallPilot
server.
Note: This section applies only to the U.S. Robotics 56-Kbit/s external
Sportster modem. If your modem is different, refer to the documentation
for your modem.
The following diagram shows the key components of the external modem,
including the location and required settings of the DIP switches:
Nortel CallPilot
1002rp Server Hardware Installation
NN44200-300
01.01
Standard
5.0
23 February 2007
Copyright © 2007, Nortel Networks
Nortel Networks Confidential
.