Nortel Networks NN44200-300 - Manual (Page 29)

Inspecting the server interior 29
2 Loosen the three thumbscrews at the rear of the top cover.
3 Remove the server cover by pulling the cover toward the rear of the
chassis, and then lifting it up and off.
4 Clip the lead from your ESD wrist strap to an unpainted metal section
of the chassis.
—End—
What is next?
Continue with "Inspecting the server interior" (page 29) .
Inspecting the server interior
Introduction
You should perform a visual inspection for loose components, foreign matter,
or shipping damage inside the server.
CAUTION
When working with interior components, use an ESD wrist strap to
protect static-sensitive components.
To inspect the server interior
Step Action
1 Carefully check all the cards to ensure they are fully seated on the
baseboard.
2 Check for any loose wires or foreign objects, such as loose screws,
inside the chassis.
3 Review the slot locations (see "Slot assignments" (page 15) ).
4 Do one of the following:
IF THEN
you observe any damage contact your Nortel technical
support representative.
Nortel CallPilot
1002rp Server Hardware Installation
NN44200-300 01.01 Standard
5.0 23 February 2007
Copyright © 2007, Nortel Networks Nortel Networks Confidential
.