NETGEAR 54 Mbps Wireless ADSL Firewall DG834G - Manual (Page 151)

NETGEAR VPN Configuration B-1
v1.0, May 2008
Appendix B
NETGEAR VPN Configuration
DG834G v5 to FVL328
This appendix is a case study on how to configure a secure IPSec VPN tunnel from a NETGEAR
DG834G v5 to a FVL328. This case study follows the VPN Consortium interoperability profile
guidelines (found at
http://www.vpnc.org/InteropProfiles/Interop-01.html ).
Configuration Profile
The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify that the firmware is up to date, and that you have all the addresses that will be
necessary, and all of the parameters that need to be set on both sides. Check that there are no
firewall restrictions.
Table B-1. Profile Summary
VPN Consortium Scenario: Scenario 1
Type of VPN LAN-to-LAN or Gateway-to-Gateway (not PC/Client-to-Gateway)
Security scheme: IKE with Preshared Secret/Key (not certificate-based)
IP Addressing:
NETGEAR-Gateway A Static IP address
NETGEAR-Gateway B Static IP address