Paradyne 4929 DSLAM - Manual (Page 79)

6. Command Line Interface
4929-A2-GN20-00 March 2005 6-5
Using the CLI to Establish Inband Management
CLI Set commands are used to establish inband management. For example:
set slot 1 ip_address 137.182.10.251
set slot 1 subnet_mask 255.255.255.0
set slot 1 default_gateway 137.182.10.10
set slot 1 inband_management on
The DSLAM in this example can now be managed with NMS by attaching a PC to
the DSLAM’s 10/100/1000 port and opening the address 137.182.10.251 in a web
browser.
PROTOCOL [ALL,IP,VALUE]
Changes the protocol filter.
RESET None.
SNMP_READONLY_COMMUNITY None. You will be prompted for values.
SNMP_READWRITE_COMMUNITY None. You will be prompted for values.
STATIC_MAC xx:xx:xx:xx:xx:xx
Sets static mac addresses.
SUBNET_MASK xxx.xxx.xxx.xxx
SUPERUSER_PASSWORD None. You will be prompted for values.
SYSTEM_NAME [system_name]
Changes the DSLAM System Name and CLI
Prompt.
VLAN_RANGE VLAN_RANGE:
SHOW: [ALL,1–10]
SET: [1–10]
VLAN_ID: [0–4085]–[0–4085]
Table 6-2. Set and Show Command Items and Values (3 of 3)
Items Values