Paradyne 4929 DSLAM - Manual (Page 78)

6. Command Line Interface
6-4 March 2005 4929-A2-GN20-00
CIRCUIT_ID circuit_ID
Changes the CIRCUIT ID.
CLEAR_NVRAM Reboots the unit and restores factory defaults
CLI_SESSION_TIMEOUT [tbd–tbd]
CLI Session Timeout sets the amount of time a
CLI session can sit idle before the user is
automatically logged out. Time is represented in
seconds; the minimum value is 30.
DEFAULT_GATEWAY xxx.xxx.xxx.xxx
Value for DEFAULT_GATEWAY is a valid IP
address.
DOWNSTREAM_INTERCONNECT [MGMT, UPLINK1,UPLINK2,UPLINK3,UPLINK4]
DYNAMIC_MAC Number of dynamic MAC addresses that can be
learned on this port.
ETHER_TYPE [8100,9100]
Changes the Backbone tag type.
FIRMWARE_VERSION None. Displays the firmware version.
FLOOD [UPL,VLN]
GENERAL_PASSWORD None. You will be prompted for values.
IGMP [dump,stop,snoop 225.1.1.2 123,clear]
INBAND_MANAGEMENT [ON,OFF]
INBAND_MGMT_VLAN_ID [0–4085]
IP_ADDRESS xxx.xxx.xxx.xxx
Value for IP_ADDRESS is a valid IP address.
IP_RANGE SET: [1–4]
SHOW: [ALL,1–4]
LAYER2_ENABLE [on,off]
Enables or disables Layer 2 functionality.
MAC [dump,clear]
MGMT_PORT_UPLINK [on,off]
Allows the PHYSICAL management port to be an
UPLINK port.
MIM [dump,reset_stats]
PHY PHY DEBUG args->cmd phy_num reg val
PRIORITY [0–7]
Table 6-2. Set and Show Command Items and Values (2 of 3)
Items Values