Paradyne 4929 DSLAM - Manual (Page 76)

6. Command Line Interface
6-2 March 2005 4929-A2-GN20-00
Launching the Terminal Emulation Program
Launch the terminal emulation program on your PC and configure the program
settings. Actual configurations will depend upon the program being used, though
settings should be modeled after the list below; most are standard defaults. Refer
to your terminal emulation program’s user manual for further information.
Logging Into the CLI
Once your terminal emulation program has been launched, device information is
displayed, followed by a request for username and password. You must log in as a
superuser in order to make configuration changes.
After you have logged in, enter a question mark (?) to list the available commands.
CLI Commands
The CLI supports the following commands:
Baud: 9600 Port: Com 1
Data Bits: 8 Stop Bits: 1
Flow Control: none Transmit Delay: n/a
Parity: none
Username: superuser
Password: Password
Table 6-1. CLI Commands (1 of 2)
Command Description
? Lists available commands and their syntax.
ALLOW Controls by IP address those hosts for which traffic is
permitted on the DSLAM. ALL (the default) permits all
traffic.
Syntax:
allow [ALL, IP_ADDRESS [IP address]]
CLEAR_NVRAM Clears Non-Volatile Random Access Memory, restoring the
DSLAM to factory defaults.
DISABLE_TELNET Disables access to the DSLAM using Telnet.
DISABLE_TFTP Disables access to the DSLAM using Trivial File Transfer
Protocol.
DISABLE_WEB_SERVER] Disables access to the DSLAM using the web server.
ENABLE_TELNET Enables access to the DSLAM using Telnet.
ENABLE_TFTP Enables access to the DSLAM using Trivial File Transfer
Protocol.