Paradyne 4929 DSLAM - Manual (Page 27)

3. Cabling
4929-A2-GN20-00 March 2005 3-3
Connecting the ADSL2+ and POTS Connectors
DSL connector supports the tip and ring connections of up to 24 DSL ports over a
50-position cable. A POTS (plain old telephone service) splitter connector is also
provided in certain models. If your model does not contain an integrated POTS
splitter, you must connect the unit to a separate POTS splitter.
To cable the DSL Ports:
Procedure
1. Insert a cable tie (provided) through the top of the anchor mount next to the
ADSL2+ connector.
2. If the connector for your cable has a short captive screw, attach the cable to
the ADSL2+ connector and fasten it to the jack screw with its short captive
screw.
3. If the connector for your cable has a long captive screw, remove the provided
jack screw from the threaded hole next to the ADSL2+ connector. Attach the
cable connector to the unit using the long captive screw.
4. Tighten the cable tie around the connector and trim the excess.
5. If you are using an integrated POTS splitter, repeat Step 1 through Step 4 ,
substituting POTS for ADSL2+.
Short
Screw
#4-40
Jack Screw
02-17083
Anchor
Mount
50-Pin
Connector
02-17346
Anchor
Mount
50-Pin
Connector
Long
Screw
02-17084