Polycom DOC2238A - Manual (Page 65)

MGC+ Hardware and Installation Manual
2-45
4. Use the Microsoft Unplug or Eject Hardware procedure prior to
removing the Flash disk.
5. Remove the Compact Flash Memory disk from the reader.
6. Insert the Compact Flash disk into the MGC+ Control Module Compact
Flash slot.
7. Press Reset on the MGC+.
The Options menu appears.
8. Press “1, Change the MGC+ IP Setting”
The Flash Memory LED must be active and flash.
9. Press Eject, after the message “1 File(s) copied” is displayed
onscreen and the Flash Memory LED no longer flashes.
10. Remove the Compact Flash card from the MGC+ Control Module
compact flash slot and press Reset on the MGC+.
11. Connect the MCU to your site’s network.
12. In the MGC+ Manager, define a new MCU using the IP address you have
entered in the LAN.CFG file:
a. In the Browser pane, right-click the MCUs Network icon, and then
click New MCU.
If no monitor is connected, the automatic default time-out selects option 1.
Do not press the Reset button while the Flash Memory LED is flashing.