Mgc+ readimanager installation, Mgc+ readimanager installation -12 – Polycom DOC2238A User Manual
Page 32
Chapter 2 - Hardware Installation
2-12
MGC+ ReadiManager Installation
The ReadiManager IAM can be installed with the MGC+ unit ON or OFF.
Refer to Table 2-2 on page 2-12 for more detailed instructions.
It is important that you follow the sequence of steps as defined in sections
below.
Table 2-2: MGC+ Power Setting During ReadiManager IAM Blade Installation
MGC+ Power
Setting
Do This
OFF
1
Make sure the MGC+ is turned OFF.
2
Remove the blank panel from the front of the MGC+
unit. (This is where the ReadiManager IAM will be
inserted.)
See “Removing the Blank Panel from the MGC+ Unit”
on page 2-14.
3
Remove the rear I/O panel and install the I/O card on
the chassis.
See “Installing the I/O Card for the ReadiManager
IAM” on page 2-15.
4
Install the ReadiManager IAM.
See “Inserting the ReadiManager IAM into the MGC+
Unit” on page 2-16.
5
Turn ON the Power switch on the MGC+.