Connecting and setting up the mgc+100, Mgc+100 dongle, Connecting and setting up the mgc+100 -17 – Polycom DOC2238A User Manual

Page 37: Mgc+100 dongle -17, Connecting the mgc+ unit to the lan network, Connecting the mgc+ unit to the network(s)

MGC+ Hardware and Installation Manual

2-17

Connecting and Setting Up the MGC+100

Use the MGC+100 rear panel diagram below for reference.

Figure 2-8: MGC+100 Rear Panel with External Connectors

To Connect the MGC+100 to the network and power source and set up
the system the following procedures are performed:

•

Connecting the MGC+ unit to the power source (AC inlet)

•

Connecting the MGC+ unit to the LAN Network

•

Connecting the MGC+ unit to the Operator Workstation (PC) directly via
RS-232 (optional) using COM2

•

Connecting the MGC+ unit to the network(s)

MGC+100 Dongle

MGC+100 is shipped with a serial dongle and is installed on COM1 of the
Control Module rear I/O panel. A special bracket ensures that the dongle
remains in its fixed position. The dongle is required for normal operation of
the MCU. If the dongle is missing, please contact support.

AC Inlet

Main Switch

Fan

DEBUG

LINE IN

COM2

COM1

KEYBOARD

MOUSE

VGA

LAN