To install the mpi-4/8 network interface module – Polycom DOC2238A User Manual
Page 42
Chapter 2 - Hardware Installation
2-22
Figure 2-11: MPI Box rack mounting options
To install the MPI-4/8 Network Interface Module:
1.
Slide the MPI-4/8 Network Interface module into a free slot in the MGC
front panel.
2.
Push the MPI-4/8 Network Interface module firmly into the Backplane,
making sure it is properly seated in its slot.
3.
Tighten the screws on the front panel of the MGC-100 that secure the
MPI-4/8 Network Interface module.
MCUs in
23" Rack
MPI Boxes
in 23" Rack
MPI Boxes
in 19" Rack
Mounting
Plate
Power
Out
In
Power
Out
In
Power
Out
In
POLYCOM R
MGC+
Stby
Fail
Active
Stb y
Fa il
Active
Stby
Fail
Active
St by
Fail
Active
Stby
F ail
Active
Stby
Fail
Active
Stby
F ail
Active
Stby
F ail
Active
Stby
Fail
Active
St by
Fail
Active
Stby
Fail
Active
Stby
Fail
Active
Stby
Fail
Active
Stby
Fa il
Act ive
Stby
Fail
Active
Stby
Fail
Active
Line 1
Line 1
Line 2
Line 2
Line 3
Line 3
Line 4
Line 4
Line 5
Line 6
Line 7
Line 8