Polycom DOC2238A - Manual (Page 60)

Chapter 2 - Hardware Installation
2-40
Compact Flash Memory Use on the MGC+
The Main Control Unit’s Compact Flash port is used to perform the following
tasks:
• pSOS Rescue Disk
— Contact you next level of support
• Swapping the Operating System (OS)
— Contact your next level of support
• First Entry MGC+ Control Unit (CU) IP Configuration using:
— pSOS OS
— XPEK OS
The Compact Flash slot is located on the Main Control Module, below the
Flash Memory LED. When the Flash Memory is active, the LED
flashes.
Power
Out In
Power
Out In
Power
Out In
POLYCOM R
MGC+
Line 1
Line 1
Line 2
Line 2
Line 3
Line 3
Line 4
Line 4
Line 5
Line 6
Line 7
Line 8
Flash Memory Card
Eject Button
Do not press the Reset button or turn the system OFF while the Flash Memory
LED is flashing.