Philips - HTS8160B - Manual (Page 35)

33
Picture
No picture.
Ensure that the TV is switched to the •
correct source for this home theatre.
No picture on HDMI connection.
If the • [HDMI Video] setting has been
changed, press HDMI on the remote
control repeatedly until the picture
appears.
Check whether the HDMI cable is faulty.
•
Replace with a new HDMI cable.
No high-deÀ nition video signal on the TV.
Ensure that the disc contains high- •
deÀ nition video.
Ensure that the TV supports high-
•
deÀ nition video.
Sound
Audio and video are not synchronised.
Press • AUDIO SYNC until ‘ AUDIO
SYNC XXX ’ is displayed.
Within À ve seconds, press
• +/- .
No sound.
Ensure that the audio cables are •
connected and select the correct input
source (for example, AUDIO SOURCE ,
USB ) for the device you want to play.
No sound from TV programme.
Connect an audio cable from the audio •
input on this home theatre to the audio
output on your TV. Then press AUDIO
SOURCE repeatedly to select the correct
audio source.
10 Troubleshooting
Warning
Risk of electric shock. Never remove the •
casing of the product.
To keep the warranty valid, never try to repair
the product yourself.
If you have problems using this product, check
the following points before you request service.
If you still have a problem, register your product
and get support at www.philips.com/welcome.
If you contact Philips, you will be asked for the
model and serial number of your product. The
model number and serial number are on the
back or bottom of your product. Write the
numbers here:
Model No. ____________________________
Serial No. _____________________________
Main unit
The buttons on this home theatre do not
work.
Disconnect the home theatre from the •
socket for a few minutes, then reconnect.
The home theatre does not respond to the
remote control.
Ensure that the home theatre is •
connected to the socket.
Ensure that there is nothing blocking the
•
remote control from the home theatre.
Point the remote control directly at the
•
IR sensor of the home theatre.
Ensure that the batteries in the remote
•
control are inserted correctly.
Use new batteries.
•
English
EN
1_HTS8160B_98_EN.indd 33 8/12/2009 2:12:48 PM