Psion Teklogix Vehicle-Mount Computer 8525 G2 - Manual (Page 137)

Psion Teklogix 8525 G2/8530 G2 Vehicle-Mount Computer User Manual 113
Chapter 5: Configuration
Narrow Band Radio Setup
5.5.8.3 Protocol Tab
Enable Cellular Protocol
The value assigned to this parameter must be identical to the value assigned to the
corresponding parameter in the Psion Teklogix Network Controller, Wireless
Gateway or Base Station. A warm reset of the 8525 G2/8530 G2 is required before
this parameter can take effect.
If Enable Cellular Protocol is disabled (unchecked), the options in the Cellular Radio
Address frame are displayed in grey text indicating that they cannot be accessed.
Cellular Radio Address
Auto Radio Address
If Auto radio address is enabled, the 8525 G2/8530 G2 requests an automatically
assigned radio address. Manual radio address is displayed in grey text indicating that
it cannot be accessed.
Manual Radio Address
The value entered in the Manual Radio Address parameter is used to identify the
8525 G2/8530 G2 over the radio link. A unique value from 1 to 3840 must be
assigned for each unit.
Note: This parameter is set to ‘0’ (an out-of-range value) by default to block
radio communication when the unit is initially powered up. This prevents
several new terminals from attempting to communicate with the same
default terminal number at initial power up. Once the default value is
changed, it cannot be set back to ‘0’.