Philips DIGA DMR-XS350EB - Manual (Page 120)

120
RQT9431
General Issues
Power
Page
No power.
The unit does not turn on pressing
[^]. Insert the AC mains lead securely into a known active household mains
socket.
Linked timer recordings with external equipment is in recording standby
(“EXT-L” on the unit’s display blinks when [^] is pressed). Press [EXT LINK] to
cancel the recording standby. •
•
10, 11
62
The unit switches to standby
mode. One of the unit’s safety devices is activated. Press [8] on the main unit to
turn the unit on. • −
The unit is turned in standby
automatically. If you connected this unit to an “HDAVI Control” compatible TV with an HDMI
cable, or connected this unit to a Q Link-compatible TV with a fully wired 21-
pin Scart cable, this unit will be automatically set to standby mode when the
TV is set to standby mode. • 84
This unit turns off when the TV
input is switched. If connected with an HDAVI Control 4 compatible TV (VIERA) with the
“Intelligent Auto Standby” setting activated on the TV, when switching the TV
input, the unit will be automatically turned to standby. For details please read
the operating instructions of the TV. • −
General Issues
Displays
Page
The display is dim. Change “Unit’s Display” in the Setup menu. • 101
“0:00” is flashing on the unit’s
display. Set the clock. • 15
The displayed time of this unit is
different from the actual recording
time or MP3 recording time. Times shown may disagree with actual times.
-R -R DL +R +R DL The remaining capacity does not increase even if titles
are deleted.
Available space on a DVD-RW (DVD-Video format) or +RW disc increases
when you delete the last title (space may increase slightly when you delete
other titles).
If you record or edit about 200 times or more, the remaining capacity of DVD-
R, DVD-R DL, +R, and +R DL is reduced and then recording or editing may
be disabled (for the second layer on DVD-R DL and +R DL, this happens after
about 60 times).
While searching, the elapsed time may not be displayed accurately.
•
•
•
•
•
−
−
−
−
−
Compared to the actual recorded
time, the elapsed time displayed
is less.
(Only when recording in NTSC) The displayed recording/play time is converted from the number of frames at
29.97 frames (equal to 0.999 seconds) to one second. There will be a slight
difference between the time displayed and the actual elapsed time (e.g.,
actual one-hour elapsed time may display as approximately 59 minutes 56
seconds). This does not affect the recording. • −
The clock does not display on the
unit when switched to standby. Ensure “Power Save” is set to “Off”. • 104
Available disc space display is
showing different from what was
used Available disc space display may be different from actual. Varying may be
large especially when recorded in DR mode. • −
Troubleshooting Guide