Philips DIGA DMR-XS350EB - Manual (Page 11)

11
RQT9431
Quic
k Star
t Guide
STEP 2
When your television has a digital satellite tuner B
Satellite
This unit
TV
AV HDMI IN
AV
HDMI
OUT
AV1 (TV)
HDMI cable (not supplied)
21-pin Scart cable (not supplied)
DISH IN 1
DISH IN 2
To household
mains socket
AC IN
Connect only after all other connections are complete.
After completing the connections, proceed to the TV Tuning ( ➔ 13).
Refer to page 116 if “U50”, “U50 1” or “U50 2” appears on the unit’s display.
HDMI features
Please use High Speed HDMI Cables that have the HDMI logo (as shown on the cover).
When outputting 1080p signal, please use the HDMI cables 5.0 meters or less.
Set “HDMI Video Mode” and “HDMI Audio Output” to “On” ( ➔ 102). (The default setting is “On”.)
This unit incorporates HDMI™ (V.1.3a with Deep Colour, x.v. Colour™) technology (➔ 134, 135).
Video sources converted to 1920 × 1080 resolution, while of high quality, will exhibit somewhat lower subjective
image resolution than true, native 1080p full-HD sources. See dealer for details.
Notes
The freesat channel uses Astra 2 at 28.2° East, and Eurobird 1 at 28.5° East satellites. To ensure your satellite
dish is correctly installed please consult your freesat registered dealer.
If you connect 2 satellite dishes for different satellites (e.g., DISH IN 1: Astra 28.2, DISH IN 2: Astra 19.2), the unit
cannot receive the signal correctly.
You can use the unit as one tuner when connecting DISH IN 1 to a satellite dish that can receive SKY.
If connecting to equipment that is only compatible with 2 channel audio output, audio with 3 channels or more will
be down-mixed ( ➔ 134) and output as 2 channels, even if connecting with an HDMI cable (some discs cannot be
down-mixed).
For display units compatible with HDCP (High-Band width Digital Content Protection) that are equipped with a
digital DVI input terminal (PC monitors, etc.):
Depending on the unit, picture may not display properly or at all when connecting with a DVI/HDMI switching cable
(audio cannot be output).
If you connect a DVI device that is not compatible with HDCP, set “HDCP on HDMI Output” in the Setup menu to
“Off” ( ➔ 102).
Tips
You can check the satellite signal condition using “Signal Condition” in the Setup menu ( ➔ 96).
When the unit is not to be used for a long time
To save power, unplug it from the household mains socket. This unit consumes a small amount of power,
even when it is turned in standby.
[approx. 0.4 W (“Power Save” is set to “On”)]
•
•
•
•
•
•
•
•
•
•
•
•
Connecting with a
Panasonic TV (VIERA)
If the 21-pin Scart cable is
connected, the Direct TV
Recording and Pause Live
TV function is available when
you view other than satellite
programme. (
➔ 37)