Lanier 5813 - Manual (Page 66)

Copying
50
2
❒ You cannot use this function for OHP transparencies, translucent paper, ad-
hesive labels and postcards.
❒ Do not use copy paper that has been already copied onto by other machines.
❒ If the copy paper is bent, correct it before placing paper in the bypass tray. If
the bent is not corrected, a paper misfeed might occur.
A
Open the bypass tray.
B
Insert the paper into the bypass tray.
Note
❒ Make sure the front side (the side that has been copied onto) faces down.
❒ Make sure that you place your original and the copy paper in the correct
direction to achieve the results required.
⇒ P.49 “Copying onto the reverse
side of paper”.
C
Press the [Normal], [Thick] or [Extra Thick] key.
D
Press the [Duplex Back] key.
Note
❒ To copy onto custom size paper, press the [Custom Size] key and select or
enter the size. For details,
⇒ P.45 “Copying onto custom size paper with the
bypass tray”.
E
Press the [OK] key.
F
Adjust the paper guides to the paper size.
Note
❒ Make sure that the paper guides match the paper size. If the paper guides
are not adjusted to the paper size properly, paper might be skewed or a pa-
per misfeed might occur.
G
Place your originals, and then press the
{{{{Start}}}} key.
Cattleya2-2_FM.book Page 50 Thursday, December 14, 2000 8:17 PM